QR pin for FSB
Moderators: e292644, blueeyedwolf
-
Iamscotticus
- L
- Posts: 87
- Joined: Thu Nov 16, 2017 9:00 pm
Has anyone found a quick release pin to replace the roll pin thsy connects the front sight halves? Is this a bad idea? The heat extremes might destroy a spring. Perhaps a cotter pin of sorts.
-
Arkane
- C
- Posts: 150
- Joined: Tue Jun 20, 2017 12:35 pm
Just kicking it around a cotter pin might not give you a good lockup. Now a short bolt of the proper diameter and either flange or cap nut might be doable and keep things nice and tight when installed.
Is the front sight assembly a problem in your optic? If so what are you running?
Is the front sight assembly a problem in your optic? If so what are you running?
-
e292644
- Site Admin
- Posts: 453
- Joined: Thu Apr 20, 2017 5:47 pm
- Country: USA
- Location: AZ
- Contact:
You do not have the required permissions to view the files attached to this post.
-
Iamscotticus
- L
- Posts: 87
- Joined: Thu Nov 16, 2017 9:00 pm
Not a prolem yet, slght ghosting wirh my 3x ACOG on TA60 mount, but want to go lower for my small noggin.
Until the aftermarket cranks out a low-pro flip (MFI), i may run front sightless but keep it handy JIC. I woud need a tool-less field solution for attachment. No plastic parts.
What is the diameter and length of that hole?
Thanks, Scott
Until the aftermarket cranks out a low-pro flip (MFI), i may run front sightless but keep it handy JIC. I woud need a tool-less field solution for attachment. No plastic parts.
What is the diameter and length of that hole?
Thanks, Scott