Title says it all. I've made do by just hitting it with a rubber mallet until it closed -- but now the upper is showing signs of wear which I think are abnormal. I know I should have just used a thin screw driver to push the rounded detente in until it would close, but I didn't realize it until recently.
Has anyone had a similar issue? I'm planning on calling Wolf tomorrow to see if this is fixable.
Wolf A1 upper - ejector port door won't close
Moderators: e292644, blueeyedwolf
-
e292644
- Site Admin
- Posts: 453
- Joined: Thu Apr 20, 2017 5:47 pm
- Country: USA
- Location: AZ
- Contact:
Have you try to clean it and apply lube or CLP direct into the detent?
-
darkarmour
- II
- Posts: 15
- Joined: Thu Mar 22, 2018 11:58 pm
- Country: USA
- Location: PA
Yup -- it was one of the first things I tried. I'll see if Steve (at Wolf) can help with it.
-
Iamscotticus
- L
- Posts: 87
- Joined: Thu Nov 16, 2017 9:00 pm
Some guys have replaced the door with a MILSPEC AR15 door.
The parts may be better for you.
The parts may be better for you.