Canted sight block
Moderators: e292644, blueeyedwolf
-
likestoshootstuff
- I
- Posts: 3
- Joined: Mon Jul 30, 2018 3:17 pm
- Country: USA
- Location: FL
I just got done setting up my new 12.5 upper and tried to zero in the sights with a laser boresight. I ran out of adjustment before I could get it to zero. I tried 3 more rear sights and a different boresight and still the same. You can physically see that the gas block/sight is canted a little. I left a message at Wolf, I'll be waiting to hear back from them. Has anyone else experienced this?
-
Iamscotticus
- L
- Posts: 87
- Joined: Thu Nov 16, 2017 9:00 pm
its a real thing. already been discussed.
I dont know if the SBs have had the issue.
I havnt seen it in mine, but I havnt checked either. Good optic and runs Im good with that.
I dont know if the SBs have had the issue.
I havnt seen it in mine, but I havnt checked either. Good optic and runs Im good with that.
-
likestoshootstuff
- I
- Posts: 3
- Joined: Mon Jul 30, 2018 3:17 pm
- Country: USA
- Location: FL
I sent it back and they put a different barrel on. All good now.
-
e292644
- Site Admin
- Posts: 453
- Joined: Thu Apr 20, 2017 5:47 pm
- Country: USA
- Location: AZ
- Contact:
Glad it all worked out.
-
Iamscotticus
- L
- Posts: 87
- Joined: Thu Nov 16, 2017 9:00 pm
I sent my upper in to Wolf and they fixed it.
A bit too fixed, but better.
They must have sent it back out the next day.
Turn around was fast.
A bit too fixed, but better.
They must have sent it back out the next day.
Turn around was fast.